Articles Page 2

mechanics •Jun 1, 2026

Thin-Kerf vs Full-Kerf Table Saw Blades: Load and Stability

Understand the mechanical tradeoffs between thin-kerf and full-kerf table saw blades, including motor load, cut width, plate stiffness, material waste, and riving knife compatibility.

mechanics •May 24, 2026

8-1/4-Inch Table Saw Blades: Why Compact Saws Use Smaller Blades

Learn why compact jobsite table saws often use 8-1/4-inch blades, how blade size affects cut depth, motor load, tip speed, and how they compare with 10-inch blades.

mechanics •May 24, 2026

First Table Saw Buying Guide: What Matters Before Brand or Price

A practical guide to choosing your first table saw, focusing on fence systems, table materials, safety mechanisms, and avoiding common beginner mistakes.

accessories •May 24, 2026

Kerf Explained: What It Means for Table Saw Blades

Understand table saw blade kerf, the difference between thin and full kerf blades, and why kerf must match your saw's motor and riving knife.

mechanics •May 24, 2026

Table Saw Blade Alignment: Miter Slot, Fence, and Trunnion Checks

A protocol-based guide to checking table saw blade alignment, separating runout from alignment error, and understanding when trunnion or fence adjustment is needed.

accessories •May 24, 2026

Table Saw Finger Joint Jig: Kerf Width, Pin Spacing, and Fit Accuracy

Understand the mechanical relationship between kerf width and pin spacing in a table saw finger joint jig to diagnose and correct cumulative fit errors.

safety •May 24, 2026

Table Saw Kickback Explained: Why It Happens & How to Reduce the Risk

Learn why table saw kickback happens, how binding at the rear teeth creates risk, and how riving knives, guards, push sticks, and setup reduce exposure.

mechanics •May 24, 2026

What Is Runout? Table Saw Arbor and Blade Wobble Explained

A mechanical explanation of table saw runout, the difference between arbor and blade wobble, and practical diagnostic ranges for woodworking.

mobility •May 24, 2026

Table Saw Setup for a Small Garage: Space, Outfeed, Dust, and Safety

A practical guide to setting up a portable table saw in a small garage shop. We cover outfeed solutions, table saw stands, dust control, and layout for safety.

mechanics •May 24, 2026

What Size Table Saw Do You Need for a Garage Shop?

A practical guide to choosing the right table saw size for a garage shop, including 8-1/4 vs 10-inch blades, rip capacity, footprint, and outfeed support.

mechanics •May 23, 2026

Table Saw Blades Explained: Tooth Count, Kerf, and Cut Quality

An engineering-minded breakdown of 10-inch table saw blades. Learn how tooth count, kerf width, grind geometry, and hook angles dictate real-world cut quality.

mechanics •May 23, 2026

Table Saw Dado Blades: Fit, Arbor Length, Throat Plates & Safety

Not all table saws can run a dado stack safely. Learn how to check arbor length, dado width, throat plate fit, motor load, and brake-system compatibility before buying.